KOBIT sweeper K10

The largest for many uses

  • special clear construction and low maintenance work
  • simple and low loss-making drive assembly guarantee
  • the complete motorpower reachs the high performance suck-fan

The standard engine for the type KOBIT K8 is a diesel engine, type CAT C3.6V, 75 kW (Stage 5 / Tier 4 Final) for the assembly of the high performance suck fan and the sweeping aggregates. It can be installed on every technical suitable chassis with a wheel distance of 3.900 mm or bigger.

The waste tank (on your request completely produced by stainless steel 1.4301) is a selfcarrying bucket construction.

The fresh water tank in the bottom of the construction and the waste tank are weld together. This construction principle guarants a high stability.

The front part of the container is also the place for the engine and the suck fan.

Details

Waste tank and engine room

  • waste tank 10,0 cbm, ground of the tank and the fresh water tank in stainless steel V2A
  • emptying by hydraulic tip out and retreat
  • flap bolting hydraulic
  • tilting angle 50 degrees, hydaulic tilt and safety rope
  • complete hopper cased with absorbing material and self quench mats

Sweeping and suck unit

  • sweeping unit at the right side, galvanized, suck unit 650 mm wide, inside coated with wear-resitant rubber, disc brush 700 mm diameter
  • suck unit is connected with the waste tank by a 250 mm diameter suck tube
  • pulled roller brush
  • sweeping wide 2.500 mm

Control

  • control desk left side of the driver, ergonomic and in well reach, includes hour counter, motor supervision and water control

Vehicle equipment

  • minimum 26 t total weight (depending on chassis)
  • Wheelbase at least 3.900 mm
  • reinforced frame and reinforced springs

Technical Data

KOBIT sweeper K10
Superstructure motorCAT C3.6V, performance 2.200 U/Min. 75 kW (Stage 5 / Tier 4 Final)
Cubic capacity4.500 cm³
Performance75 kW (102 PS)
Speed1.200 – 1.800 min
Container/Water tank
Dirt container contents10,0 m³
fresh water tank *2.600 l - 5.500 l
Sweeping-/suction power
Transport width **2.900 - 4.100 mm
Suction fan performancemax. 18.000 m³/h
Suction fan speedmax. 3.300 min
suction pressure in sweeping modeabout 1.000 mm WS
max. suction pressure1.300 mm WS
Sweeping Speed ***2 – 18 km/h
Noise levels
at max. fan power78 dB (A)
* depending on the chassis
** disc brush, suction mouth and roller brush
*** dependent on the gearbox